SMF - Just Installed!
Started by Andy Brown, January 28, 2015, 01:39:34 pm
ubuntu@ubuntu:~$ sudo flashrom -p internal -r bios.binflashrom v0.9.6.1-r1563 on Linux 3.13.0-32-generic (i686)flashrom is free software, get the source code at http://www.flashrom.orgCalibrating delay loop... OK.Found chipset "Intel ICH10R". Enabling flash write... WARNING: Setting 0xdc from 0x2 to 0x3 on ICH10R failed. New value is 0x2.WARNING: SPI Configuration Lockdown activated.PR0: WARNING: 0x001f0000-0x001fffff is read-only.Please send a verbose log to firstname.lastname@example.org if this board is not listed onhttp://flashrom.org/Supported_hardware#Supported_mainboards yet.Writes have been disabled. You can enforce write support with theich_spi_force programmer option, but it will most likely harm your hardware!If you force flashrom you will get no support if something breaks.PROBLEMS, continuing anywayFound SST flash chip "SST25VF016B" (2048 kB, SPI) at physical address 0xffe00000.Reading flash... done.
Quote from: 429076 on June 20, 2017, 01:57:10 amHi everyone. I've tried this image and it works. Thanks for the image.I've started with z800 rev 002 stock BIOS chip, not working with 56xx processors. Tried to flash it in place (without any soldering). And I've got interesting result - I am able to erase the chip, but can't write new image to it.So the BIOS was spoiled and I proceeded with the long way. I've unsoldered the chip and tried to flash it separately, but it was still read only (or maybe I've had some issues with my programmer). I've had some new spare chips, and flashed the image to new one without any errors. And now motherboard boots with 56xx processors, and has new boot block.